Welcome to the new Heckler website. Need help or want to share feedback? Use chat or the Feedback tab.

Heckler
Skip to guide content
Resource LibraryUser GuidesH549

In this guide

H549 · iPad Air 13-inch / Pro 12.9-inch (3rd–6th Generation)

WindFall STAND Secure Stand for iPad Air 13-inch & iPad Pro 12.9-inch (3rd 4th 5th and 6th Generation)

Fit the stand feet, install the iPad and retaining brackets, and review cable routing and countertop mounting.
iPad fitted in the H549 WindFall Stand.

This guide is also available as a printable PDF.

Letter PDFA4 PDF
Applies to
H549 for iPad Air 13-inch and iPad Pro 12.9-inch, 3rd, 4th, 5th, and 6th Generation, as stated in the source.
Assembled angled WindFall Stand with an iPad held in its landscape frame.

Compatible with:

iPad Air 13-inch

iPad Pro 12.9-inch (3rd, 4th, 5th, and 6th Generation)

Limited Warranty

For warranty coverage and terms, see the Heckler Warranty Policy. For warranty support, contact service@heckler.com.

In The Box

  • 1 x Secure Stand
  • 1 x Assembly Tool (F529)
  • 4 x Felt Feet (F581)
  • 4 x Friction Feet (S130)
Parts diagram showing the F529 hex key, four F581 felt feet, and four S130 friction feet.

Select then install feet

Underside diagrams show four S130 friction feet on the left and four F581 felt feet on the right, positioned at the corners of the stand base.

Loosen and remove screws

Rear view with the hex key at the right bracket screws, two left bracket screws retained, and close-up of a loosened screw.

Remove right-hand tablet bracket and cord securer

Right-hand tablet bracket and small cable retainer separated from the stand, with an outward arrow.

Install the iPad Air 13-Inch

iPad sliding left beneath the retained bracket, shown by a left-pointing arrow.

Route your USB-C cable and reinstall right-hand tablet bracket

USB-C cable routed through the stand opening and around the tablet edge, with the right bracket and its screws aligned over the tablet.

Fasten cord securer

Cable retainer positioned over the USB-C plug, with its two screws and a close-up of the retainer around the cable.

Tighten all screws

Rear view identifying the left and right bracket screws, with close-ups showing their seated heads.
Completed landscape iPad installation in the stand, accompanied by a check mark.

Counter Mounting

Two separately sold screws aligned with holes in the stand base for attachment to a countertop.

PivotTack

PivotTack accessory shown through the stand base into a countertop; the accessory is marked sold separately.

PivotTable

Exploded view of a PivotTable beneath the stand base, with its central screw, washer, and spacer above; accessory sold separately.

Kensington Nano ClickSafe Cable Lock

Kensington Nano ClickSafe cable lock connected at the stand base; accessory sold separately.

Kensington ClickSafe Cable Lock

Kensington ClickSafe cable lock attached to the stand base; accessory sold separately.