H658 · iPad mini 6th Generation

OnWall Mount for iPad mini 6th Generation

Mount the wall pocket and install iPad mini 6th Generation, its adapter, and cabling.

This guide is also available as a printable PDF.

Letter PDF A4 PDF

In the box

1 x Heckler OnWall Mount

2 x Drywall Anchor (F155)
2 x Drywall Mounting Screw (F360)
1 X Cable Tie (F817)
1 x Enclosure Assembly Key (F529)
1 x Set Screw Assembly Key (F914)
1 x Right-angle USB-C adapter (F102)

Components labeled A–G: OnWall Mount, drywall anchor, mounting screw, coiled cable tie, standard hex key, ball-end hex key, and right-angle USB-C adapter.

Mount the pocket to your wall

Determine your installation height

Wall-height diagram with a 48-inch dimension from the finished floor to the top edge of the screen opening.

Review the hole and slot patterns on the pocket

Rear pocket diagram: outer vertical slots are labeled for drywall mounting, inner horizontal slots for US single-gang and European wall boxes, and the center round hole for the CAT cable.

Hold the enclosure against the drywall at the desired installation height

Mark the two screw positions and the CAT cable hole position as shown.

Assembled mount held against the wall, with two outer screw positions highlighted and a round cable opening between them.

Remove the tablet enclosure from the pocket

Two-frame animation showing a hex key at a lower set screw, then the pocket tilted away from the tablet enclosure.

Option 1: Mount directly to drywall

Animation showing two wall anchors, a CAT cable emerging through the center hole, and the pocket secured with two mounting screws.

Option 2: Mount to a US single-gang box

For a landscape installation on a wall box, install an old-work US single-gang box horizontally in the wall. The gang box and screws are not included.

Animation showing a horizontal US single-gang box installed in the wall, its cable fed through the pocket, and the pocket attached with two screws.

Option 3: Mount to European wall box

The wall box and screws are not included.

Animation showing a European wall box installed in the wall, its cable fed through the pocket, and the pocket attached with two screws.

Install your PoE adapter inside the pocket

PoE adapter positioned horizontally inside the wall pocket, with its cable on the left and USB ports on the right.

Install the iPad mini 6th Generation

Loosen the top and bottom enclosure brackets

Rear view of the empty enclosure, with four bracket screws marked and a hex key aligned with one screw.

Install the iPad mini 6th Generation into the enclosure

Carefully slide the iPad mini from the open end of the enclosure, past the loosened brackets.

Slide the iPad mini until it fully engages with the tab on the far side of the enclosure.

Three-frame animation showing the iPad sliding beneath the enclosure brackets until seated against the far-side tab.

Connect the right-angle USB-C adapter and Apple USB-C cable

Three-frame animation showing the USB-C cable connected to the right-angle adapter, followed by the adapter inserted into the iPad port.

Tighten the enclosure-bracket screws

Rear view of the installed iPad and connected adapter, with four bracket screws marked and a hex key aligned with one screw.

Your iPad mini enclosure is now prepared to be mounted to the pocket.

Install the tablet enclosure to the pocket

Connect the charging cable to the PoE adapter (optional)

Transparent view of the assembled enclosure showing the charging cable routed from the right-angle adapter to the PoE adapter, with excess cable bundled near the bottom.

Hang the enclosure on the pocket

Four-frame animation showing the tablet enclosure angled away from the wall pocket, engaging at the top, and swinging closed around the adapter and cable.

Tighten the set screws

Using the supplied ball-end hex key, gently tighten each set screw until the enclosure is firmly fastened to the pocket.