Welcome to the new Heckler website. Need help or want to share feedback? Use chat or the Feedback tab.

Heckler
Skip to guide content
Resource LibraryUser GuidesH660

In this guide

H660

Stand for Logitech Tap & Tap IP

Route the Tap IP Ethernet cable and attach the stand to the Logitech controller.
Logitech Tap fitted to the H660 angled tabletop stand.

This guide is also available as a printable PDF.

Letter PDFA4 PDF

In the box

  • Stand for Logitech Tap & Tap IP (R627)
  • 5-meter CAT 6 nylon-braided Ethernet cable (T279)
  • 4 thumbscrews (F839)
Stand for Logitech Tap beside a coiled Ethernet cable and four thumbscrews.

Install the Ethernet cable in Tap IP

Open the hatch on the bottom of the Tap IP.

Underside of Tap IP with the circular bottom hatch lifted above its cable compartment.

Connect the included Ethernet cable.

Ethernet cable connected inside the open Tap IP compartment and routed around the inner channel toward the rear cable slot.

Close the bottom hatch.

Tap IP with its bottom hatch closed and the Ethernet cable emerging through the rear slot.

Install the stand

Fasten the stand to the Tap or Tap IP using the four thumbscrews provided.

Stand positioned above the underside of Tap IP, with four thumbscrews aligned with the stand mounting holes.
Stand attached to the underside of Tap IP with four thumbscrews, with the Ethernet cable routed through the rear opening.

Turn the assembled stand and Logitech controller upright. Installation is complete.

Front three-quarter view of Tap IP resting at an angle on the stand, with its cable extending behind it.
Rear view of Tap IP on the stand, showing the inclined support and cable emerging through the rear opening.