Welcome to the new Heckler website. Need help or want to share feedback? Use chat or the Feedback tab.

Heckler
Skip to guide content
Resource LibraryUser GuidesH714

In this guide

H714

Heckler AV Cart Base Configuration

Assemble the AV Cart base configuration, mount the display, and route power and data cables.
H714 AV Cart Base Configuration fitted with a landscape display on a four-caster frame.

This guide is also available as a printable PDF.

Letter PDFA4 PDF

In the box

  1. 1x Front Base
  2. 2x Rear Leg
  3. 2x Display Rail
  4. 4x Caster
  5. 4x Socket Head Screw, 1/2"-13, 2.75" Long
  6. 1x Assembly Key, Hex, 3/8”
  7. 4x Set Screw, M8, 70mm Long
  8. 4x Wingnut, M8
  9. 4x Set Screw, M6, 70mm Long
  10. 4x Wingnut, M6
  11. 4x Rubber Spacer
  12. 8x Screw-in Cable Mount
  13. 4x Push-in Cable Mount
  14. 8x Pan Head Screw, 10-32, 0.25” Long
  15. 8x Cable Tie
Front base, rear legs, display rails, casters, mounting hardware, assembly key, spacers, cable mounts, screws, and ties labeled A–O.

Install casters

Remove wheels from all four casters.

Caster wheel removed from the caster body.

Fasten caster bodies to legs.

Caster bodies threaded into the front base and two rear legs.

Reinstall wheels.

Wheels reinstalled in all four caster bodies.

Engage caster brakes.

Brake levers pressed down on all four casters.

Install rear legs

Two rear legs attached to the front base with socket-head screws and the supplied hex key.

Install display rails

Two display rails fastened to the front base, with an enlarged view of the lower connection.

Install display

Determine whether your display has M8 or M6 mounting holes.

Four mounting holes highlighted on the back of the display.

Insert the M6 or M8 set screws through the rubber spacers. Position the set screw relative to the spacer as shown.

M6 or M8 set screw pushed through a rubber spacer with a 1-inch protruding section shown.

Fasten the mounting hardware to the display.

Four screw-and-spacer assemblies threaded into the rear display mounting holes.

Ensure all caster brakes are engaged.

Caster brake lever pressed down before the display is installed.

Fasten display to the display rails.

Display supported on both rails and secured with the matching M6 or M8 wingnuts.

Route power and data cables

Fasten the provided zip tie anchors and zip ties to the rear of the display rail as shown.

Screw-in cable mount fastened to a display rail and a cable tie threaded through it to hold cables.

Install the provided zip tie anchors and zip ties to the rear leg as shown.

Push-in cable mount and cable tie holding cables along the rear leg.
Completed cart with display installed and cables routed along a rear leg.