Welcome to the new Heckler website. Need help or want to share feedback? Use chat or the Feedback tab.

Skip to guide content

Resource LibraryUser GuidesH755

H755 · iPad 10th Generation

Wall Mount MX for iPad 10th Generation

Mount the backplate, prepare the iPad enclosure and cables, and attach the enclosure to the wall mount.

This guide is also available as a printable PDF.

Letter PDF A4 PDF

In the box

1 x Wall Mount MX
4 x Gang box mounting screws (F913)
1 x Enclosure assembly key (F529)
1 x Set screw assembly key (F914)
1 x Cable tie (F817)

Wall Mount MX enclosure and backplate, four mounting screws, two hex keys, and a coiled hook-and-loop cable tie, labeled a through e.

Mount the backplate

Review the slot patterns on the backplate

Rear view of the assembled mount with outlined groups identifying the US double-gang box slots and the separate drywall mounting slots.

Determine the installation location and mark the mounting holes

The enclosure held against a wall, with a 48-inch dimension from the finished floor to the top edge of the screen opening.

Mark the mounting slots for the gang box.

A dashed double-gang box outline behind the backplate; four mounting positions and a 1-inch offset are marked.

Four wall marks in two rows, with an elongated mark and a round mark in each row.

Remove the tablet enclosure from the backplate

Hex key engaging a set screw along the lower edge of the enclosure backplate.

Backplate lifted away from the tablet enclosure, with two upward arrows.

Mount the backplate to a double-gang box

Cut the drywall.

Four mounting marks on the wall, shown as the first step of the gang box layout.

The gang box held over the mounting marks, with dotted lines and arrows aligning its screw positions.

A pencil traces the outline of the gang box against the wall.

Rectangular cutout outline surrounding the four mounting marks.

Rectangular opening cut into the drywall.

Install the gang box and connect the Ethernet cable.

Gang box aligned with the wall opening, with four screws shown at its mounting ears.

Gang box installed in the wall with an Ethernet cable extending through it.

Install the PoE adapter inside the gang box.

PoE adapter and connected Ethernet cable inside the gang box.

Attach the backplate to the gang box.

Animation of the backplate aligned with the gang box and secured using four screws.

Install the backplate to the gangbox.

Optional: Mount directly to drywall. Hardware sold separately.

Animation of two screws and wall anchors securing the backplate directly to drywall.

Install the iPad 10th Generation

Loosen the tablet brackets

Four enclosure brackets and their screws lifted from the frame, with a hex key at one screw.

Install the iPad 10th Generation into the enclosure and connect the USB-C cable

iPad seated behind the bezel with a USB-C cable connected at its side.

Close-up of a right-angle USB-C connector tucked behind the bezel beside the iPad.

Tighten the enclosure-bracket screws

Four retaining brackets positioned around the iPad, with a hex key turning one of the screws.

All four brackets fastened around the back of the iPad with the USB-C cable exiting at the side.

Attach the tablet enclosure to the backplate

Connect the charging cable to the PoE adapter (optional)

The charging cable connects the iPad enclosure to the PoE adapter inside the gang box.

Hang the enclosure on the backplate

Front and rear animation views of the enclosure engaging the backplate hooks and settling into place.

Hang the enclosure on the pocket

Tighten the set screws

Front view of the wall-mounted enclosure with a hex key reaching a set screw from below.

Rear view showing the hex key entering a set screw beneath the backplate.

Completed wall-mounted iPad enclosure viewed from the front.

H755 Wall Mount MX for iPad 10th Gen Installation Guide | Heckler