Welcome to the new Heckler website. Need help or want to share feedback? Use chat or the Feedback tab.

Skip to guide content

Resource LibraryUser GuidesH756

H756 · iPad 10th Generation

OnWall Mount for iPad 10th Generation

Mount the wall pocket, prepare the iPad enclosure and cables, and attach the enclosure to the pocket.

This guide is also available as a printable PDF.

Letter PDF A4 PDF

In the box

OnWall enclosure and pocket, two drywall anchors and screws, two hex keys, a round hook-and-loop dot set, and a coiled cable tie, labeled a through g.

1 x OnWall mount
2 x Drywall anchors (F155)
2 x Drywall anchor screws (F360)
1 x Set screw assembly key (F914)
1 x Enclosure assembly key (F529)
1 x Hook-and-loop dot set (F695)
1 x Cable tie (F817)

Mount the pocket to your wall

Determine the height of your installation

The enclosure held against a wall with a 48-inch dimension from the floor to the top edge of the screen opening.

Review the hole and slot patterns on the pocket

Hold the enclosure to the drywall at the desired installation height

Mark the two screw positions and the CAT cable hole position as shown.

Pencil marks through the two pocket mounting slots, with the central cable opening also highlighted.

Remove the tablet enclosure from the pocket

Hex key engages a set screw along the lower edge of the enclosure pocket.

The pocket lifts away from the enclosure frame, indicated by upward arrows.

Option 1: Mount directly to drywall

Install drywall anchors.

Two drywall anchors installed on either side of the marked cable-hole position.

Drill the hole for the CAT cable.

A circular cable hole between two installed drywall anchors.

Mount the pocket on the drywall.

Animation of the Ethernet cable passing through the pocket and two screws securing the pocket to the wall anchors.

Option 2: Mount to a US gang box

Animation of a US gang box installed in the wall and the pocket fastened over it with two screws.

Option 3: Mount to a European wall box

Animation of a European wall box installed in the wall and the pocket secured to it with two screws.

Install the iPad 10th Generation

Loosen the top, bottom, and side enclosure brackets

The top, bottom, and side retaining brackets lifted from the enclosure, with a hex key at a screw.

Position the iPad into the enclosure

iPad seated behind the bezel, with a right-angle USB-C connector at its side and a cable extending from it.

Tighten the enclosure-bracket screws

Animation of the three retaining brackets positioned over the iPad and secured with their screws.

Install your PoE adapter inside the pocket

Animation of a PoE adapter pressed onto a round hook-and-loop dot inside the pocket, with the Ethernet cable connected and excess cable bundled alongside.

Attach the tablet enclosure to the pocket

Connect the charging cable to the PoE adapter (optional)

Charging cable connects the iPad to the PoE adapter mounted inside the pocket.

Hang the enclosure on the pocket

Front and rear animation views of the iPad enclosure engaging the pocket hooks and lowering into place.

Tighten the set screws

Front view of the mounted enclosure with a hex key turning a set screw underneath.

Rear view of the pocket and the two set screws below the enclosure, with a hex key at one screw.