Welcome to the new Heckler website. Need help or want to share feedback? Use chat or the Feedback tab.

Heckler
Skip to guide content
Resource LibraryUser GuidesH757

In this guide

H757 · iPad 10th Generation

VESA Mount for iPad 10th Generation

Install the iPad and cable in the enclosure, then attach the VESA mount to an arm.
iPad fitted in the H757 VESA Mount on a display arm.

This guide is also available as a printable PDF.

Letter PDFA4 PDF

In the box

  1. 1 x VESA Mount
  2. 4 x VESA-arm mounting screws (F474)
  3. 1 x Hex key (F529)
Included components labeled a–c: VESA Mount, four VESA-arm mounting screws, and a hex key.

Remove the brackets

Exploded rear view showing two brackets lifted from the bezel, four bracket screws, and a hex key aligned with one screw.

Position the iPad 10th Generation and route your USB-C cable

The iPad positioned face down above the bezel, with arrows showing it lowering into place.
Rear view of the iPad positioned in the bezel with a USB-C cable connected directly to its side port.
Rear view of the iPad with a right-angle USB-C adapter and cable positioned along the side behind the bezel.

Reinstall the brackets

Two brackets positioned over the back of the iPad, with four screws aligned to the bezel and a hex key at one screw.
Rear view of the iPad held by the two reinstalled brackets, with the USB-C cable passing through the side opening.

Mount to a VESA arm

Exploded rear view aligning the VESA-arm plate and mounting screws with the brackets; the charging cable runs along the arm.
Rear view of the VESA-arm plate fastened to the mount brackets, with the charging cable routed along the arm.
Front view of the enclosed iPad mounted on the VESA arm.
H757 VESA Mount for iPad 10th Gen Installation Guide | Heckler