Welcome to the new Heckler website. Need help or want to share feedback? Use chat or the Feedback tab.

Heckler
Skip to guide content
Resource LibraryUser GuidesH804

In this guide

H804

Controller Mount

Attach the controller bracket, position it on AV Wall, and secure the mount and cables.
H804 mount holding a touch controller beside an AV Wall post.

This guide is also available as a printable PDF.

Letter PDFA4 PDF
Applies to
H804 Controller Mount for Heckler AV Wall.

In the box

  • 1 x Meeting Controller Bracket (R613)
  • 1 x Quick Release Pin (F936)
  • 2 x Set Screw, M4, 25mm long
  • 2 x Wingnut, M4

Compatibility

Controller Mount is compatible with:

  • Logitech Tap
  • Logitech Tap IP
  • Neat Pad
  • Neat Pad Generation 2

Fasten bracket to controller

Fasten the two provided M4 set screws into the threaded mounting positions on the underside of your controller. No tool is required.

Fasten the Controller Mount bracket to the controller using the provided wing nuts.

Exploded rear view of a controller, two set screws, the reversible bracket, and two wing nuts.
Bracket fastened to the controller’s rear mounting points.
Fasten the Controller Mount bracket to the controller using provided wing nuts.

Mount the bracket to the structure at the desired height.

Mount the bracket to structure at the desired height.

Insert a quick release pin to lock the mount to the structure.

Route cables.

Rear view showing the bracket secured to the upright with a quick-release pin and the cable routed below.
H804 AV Wall Controller Mount Installation Guide | Heckler