Important Safety Notice:
If you plan to use the mount on mobile whiteboards, be careful when rolling them through doorways. In most situations, it's advisable to remove the mount from the whiteboard to prevent any possible harm to the Logitech Scribe, the whiteboard, and the doorway.
Enlarge image ↗ Whiteboard clamp mount with its clamping knob, thrust pad, and four preinstalled screws on the rounded camera mounting plate.
Secure the Scribe Camera Mounting Bracket to the mount using the pre-installed screws.
Enlarge image ↗ Phillips screwdriver removes the four preinstalled screws from the rounded mounting plate.
Enlarge image ↗ Scribe camera mounting bracket positioned on the plate, with a screwdriver tightening its four screws.
Enlarge image ↗ Circular Scribe mounting bracket fastened to the mount, showing its locking tab and orientation arrows.
Open video .Pass the CAT5e cable between the front and rear surfaces of the mount, as shown, and connect it to the Logitech Scribe camera. Attach the camera to its mounting bracket.
Enlarge image ↗ Ethernet cable passes behind the mount to the Scribe camera as its circular base approaches the mounting bracket.
Enlarge image ↗ Scribe camera seated on its mounting bracket above the whiteboard clamp.
Enlarge image ↗ Two close-up views show the bracket tab moving into place against the front of the Scribe camera base.
Enlarge image ↗ Rear view of the Scribe camera and whiteboard mount with the network cable routed down through the mount.
Open video .As demonstrated, pass the CAT5e cable through the space between the front and rear surfaces of the mount. Then, connect the CAT5e cable to the Logitech Scribe Camera. Hang and connect the Scribe Camera to its Camera Mounting Bracket. Loosen the clamping screw on the mount to adjust it to the thickness of your whiteboard.
Enlarge image ↗ Rotation arrows around the clamping knob show the clamp being opened.
Place the mount on top of the whiteboard. Hold it vertically with one hand while turning the clamping screw with the other.
Turn the clamping screw slowly until the thrust pad firmly engages with your whiteboard. Do not overtighten the clamping screw, as this may damage your whiteboard and mount.
Enlarge image ↗ Downward arrow shows the assembled camera mount lowering over the top edge of the whiteboard.
Enlarge image ↗ Rotation arrows show the clamping knob being tightened with the mount seated over the whiteboard.
Enlarge image ↗ Close-up of the clamping screw and thrust pad aligned against the whiteboard face.
Open video .Place the mount on top of the whiteboard, While holding it vertically with one hand, use your other hand to turn the clamping screw. To remove the Scribe Camera from the Mounting Bracket, gently push down on the front tip of the plastic tab and swivel the camera off the bracket.
Enlarge image ↗ Two close-up views show the locking tab pressed downward and the Scribe base turned away from the bracket.
Open video .Enlarge image ↗ Front view of the Scribe camera installed above the whiteboard.
Enlarge image ↗ Rear view of the installed Scribe camera with the cable routed behind the clamp mount.
