Welcome to the new Heckler website. Need help or want to share feedback? Use chat or the Feedback tab.

Heckler
Skip to guide content
Resource LibraryUser GuidesH901

In this guide

H901

Modesty Panel Set for Heckler Lectern 6U

Unpack, assemble, and install the modesty panel set on Lectern 6U.
Premium H901 panels installed on a 6U lectern with monitor and touch controller.

This guide is also available as a printable PDF.

Letter PDFA4 PDF

In the box

  • One large panel
  • Two small panels
One large front modesty panel and two smaller side panels.

Unpacking

Carefully remove the three panels of your modesty panel set from the packaging.

Animation showing the modesty-panel packaging opened to reveal the panels.

Rest each panel on a towel or the packaging foam. Remove the masking paper or film from both sides of each panel.

Assembly

Modesty-panel hardware pack with thumbscrews and spacers, labeled do not discard.

Press and install a modesty panel spacer into each pill-shaped hole in the panel.

Fasten each modesty panel thumbscrew through the panel and then through the spacer. The spacer will retain the screw, creating a tool-less panel installation.

Installation

Grip the top center edge with one hand and lift the panel. Position it to align the screws with the mounting hole positions on the sides of the lectern. With your other hand, tighten each thumbscrew. Gently wiggle the panel as you tighten the thumbscrews to ensure a firm installation.

Repeat this installation process for each of the three panels. Remove the protective film placed over the custom-printed logo.

Animation showing all three panels aligned and seated around the lectern.
H901 Modesty Panel Set for Lectern 6U Installation Guide | Heckler