Casters for Heckler Lectern
This guide is also available as a printable PDF.
In the box
- Four locking casters
Safety
Installing casters on an empty lectern
Carefully position the lectern upside down on a soft surface. If leveling feet are installed on the feet, remove them.
Using your hands, partially thread the caster's threaded post into the threaded socket.
To remove the caster from its post, twist a flat-head screwdriver between the threaded post and the caster.
Use a flat wrench or socket set to tighten the post to the foot.
Pop the caster onto its post.
Repeat for all four casters.
Carefully upright the lectern.
Installing casters on a fully loaded lectern
If you want to add casters to a lectern that is already loaded with gear and tech inserts and wish to avoid rotating the lectern upside down to install the casters, follow these steps:
Remove the large modesty panel and place it on a soft surface.
Press the lectern's up button to raise the lectern to its highest position.
Remove the collision sensor from the sit/stand controller located on the underside of the lectern.
Roll the cart under the lectern. Center the cart under the lectern.
Lower the lectern until the weight of the lectern rests on top of the cart.
Carefully continue to lower the lectern until the lectern lifts its feet off of the ground. Lift the feet at least six inches from the ground.
Remove the leveling pads from the lectern feet.
To remove the caster from its post, twist a flat-head screwdriver between the threaded post and the caster.
Using your hands, partially thread the caster's threaded post into the threaded socket.
Use an adjustable open-end wrench or socket set to tighten the post to the foot.
Pop the caster onto its post while ensuring that your lectern remains stable atop your cart.
Repeat for all four casters.
Press the up button on the lectern to lower its casters to the ground. Continue doing so until the cart no longer supports the weight of the lectern.
Remove your cart from under the lectern.
Reconnect the collision sensor to the sit/stand controller located on the underside of the lectern.
Reinstall the large modesty panel.