H921

Modesty Panel Set for Lectern 4U

Unpack, assemble, and install the modesty panel set on Lectern 4U.

This guide is also available as a printable PDF.

Carefully remove the three panels of your modesty panel set from its packaging. Rest each panel on a towel or the packaging foam. Remove the masking paper or film from both sides of each panel, but leave any protective film over the custom-printed logo in place until installation is complete.

Animation showing the carton opened and the three panels removed from their protective packaging.

Assembly

Hardware package containing modesty-panel spacers and thumbscrews.

Press and install a modesty panel spacer into each pill-shaped hole in the panel.

Animation showing spacers pressed into the panel’s mounting holes.

Fasten each modesty panel thumbscrew through the panel and then through the spacer. The spacer will retain the screw, creating a tool-less panel installation.

Animation showing thumbscrews passed through the panel and retained by the spacers.

Installation

Grip the top center edge with one hand and lift the panel. Position it to align the screws with the mounting hole positions on the sides of the lectern. With your other hand, tighten each thumbscrew. Gently wiggle the panel as you tighten the thumbscrews to ensure a firm installation.

Repeat this installation process for each of the three panels.

Animation showing the complete three-panel set installed around the lectern.

Remove the protective film placed over the custom-printed logo.

Modesty Panel Set for Lectern 4U

In the box

Unpacking

Assembly

Installation