H750X WindFall Stand for iPad 10th Generation

Included components labeled a–d: WindFall Stand, four domed friction feet, four flat felt feet, and an L-shaped assembly key.

Felt feet: F581, four included. The S130 label printed in this original illustration is incorrect.

Friction feet: S130, four included. The F581 label printed in this original illustration is incorrect.

Rear view of the stand with four bracket screws lifted above their holes and a hex key aligned to one screw.

Two retaining brackets separated from the back of the stand, with arrows indicating removal.

iPad positioned screen-down over the back of the stand, with arrows indicating placement and both retaining brackets set aside.

Rear view of the iPad with both brackets in place and a USB-C cable passing between the side bracket and iPad and through the opening in the stand base.

Rear view showing the USB-C cable connected through a right-angle adapter behind the bezel and routed past the side bracket and through the stand base.

Rear view of the installed iPad with four bracket screws aligned to their holes and a hex key at one screw, with the charging cable routed behind the bracket.

Rear view of the iPad held by both retaining brackets, with all four bracket screws seated and the USB-C cable routed through the stand base.

Front view of the assembled WindFall Stand with the iPad screen visible within the bezel.

Rear view of the stand with two screw heads visible in the base for optional countertop fastening.

Rear view of the stand with a PivotTack through the central base opening and its perforated stem extending below the base.

Exploded view of a PivotTable beneath the stand base, with its central cap and screw aligned above the opening.

Rear view of a Kensington ClickSafe cable lock connected at the left side of the stand base.